Hello All,
I have been experimenting with building some native packages in the default Edison env and I royally screwed up my libc bins. So I am in need of just restoring my linux image that is in my "Edison drive" already.
However, its not as easy as I thought. I have the Arduino board and I have read about the FW and RM buttons but I am not sure I understand what they do. Here is the deal. I have no way to boot linux far enough to ask to reboot ota. What is the best way to init a reflash of my linux image? I can abort the autoboot and drop to that prompt but that is about it. Is there any instuctions on restoring the linux image from this state. I am sure its possible but I would rather see some real docs or an reply from someone that has worked the project vs. me poking around and really messing it up
Thanks,
Below is my issue however unhelpful the output may be.
Riley
******************************
PSH KERNEL VERSION: b0182727
WR: 20104000
******************************
SCU IPC: 0x800000d0 0xfffce92c
PSH miaHOB version: TNG.B0.VVBD.0000000c
microkernel built 23:15:13 Apr 24 2014
******* PSH loader *******
PCM page cache size = 192 KB
Cache Constraint = 0 Pages
Arming IPC driver ..
Adding page store pool ..
PagestoreAddr(IMR Start Address) = 0x04899000
pageStoreSize(IMR Size) = 0x00080000
*** Ready to receive application ***
U-Boot 2014.04 (Sep 08 2014 - 14:09:10)
Watchdog enabled
DRAM: 980.6 MiB
MMC: tangier_sdhci: 0
In: serial
Out: serial
Err: serial
Hit any key to stop autoboot: 0
Target:blank
Partitioning already done...
Flashing already done...
GADGET DRIVER: usb_dnl_dfu
reading vmlinuz
5124544 bytes read in 127 ms (38.5 MiB/s)
Valid Boot Flag
Setup Size = 0x00003c00
Magic signature found
Using boot protocol version 2.0c
Linux kernel version 3.10.17-poky-edison+ (sys_dswci@ncsndgbuild04) #1 SMP PREEMPT Mon Sep 8 14:09:55 CEST 2014
Building boot_params at 0x00090000
Loading bzImage at address 00100000 (5109184 bytes)
Magic signature found
Kernel command line: "root=PARTUUID=012b3303-34ac-284d-99b4-34e03a2335f4 rootfstype=ext4 console=ttyMFD2 earlyprintk=ttyMFD2,keep loglevel=4 systemd.unit=multi-user.target hardware_id=00 g_multi.iSerialNumber=cf0f861b9892037c16302780c06fbad0"
Starting kernel ...
[ 1.636982] pmic_ccsm pmic_ccsm: Error reading battery profile from battid frmwrk
[ 1.645409] pmic_ccsm pmic_ccsm: Battery Over heat exception
[ 1.645496] pmic_ccsm pmic_ccsm: Battery0 temperature inside boundary
[ 1.650009] pmic_ccsm pmic_ccsm: Battery0 temperature inside boundary
/sbin/init: error while loading shared libraries: libc.so.0: cannot open shared object file: No such file or directory